Jumper One:
Sand (208) 2 [2:2:3:3:3] 50g hanks
Dandelion (446) 1 [1:1:1:1:2] 50g hanks

Jumper Two:
Rosemary (318) 2 [2:3:3:4:4] 50g hanks

Additional Abbreviation: Sk2po Slip one, knit two stitches together, pass slipped stitch over. 2sts decreased.

Gauge should read: 30 stitches per 4 inches (10cm) in stocking stitch (worked in the round) on 2.5mm needles.

Note: These socks are knitted on 2.5mm needles not 3.25mm as stated on the ball band. This will produce a different gauge but will ensure a firmer, more hard-wearing fabric for your socks. The ideal gauge for these socks 30 stitches per 10cm (4”) so use whatever size needle are required to reach that gauge and do check that your knitted fabric is firm but not stiff.

Left Front
Shape Neck
Should say after shaping.

Cont straight till front measures the same as the back to the shoulders, ending with a WS row.

Right Front
Shape Neck
Should say after shaping.

Cont straight till front measures the same as the back to the shoulders, ending with a RS row.

Rep from **to** 4 times more. 76 sts

Now work as folls:-

Row 1 (RS): Using A, knit.
Row 2: Using A, k1, sl1, k1, psso, knit to last 2 sts, knit into front and back of next st, k1.
Row 3: Using A, knit.
Row 4: Using A, k1, sl1, k2tog, psso, knit to last 2 sts, knit into front and back of next st, k1. 75 sts.

Front Lower Border. After Picking up sts
Next Rnd Knit to end.
Rnd 1 *K1, P1, rep from * to end
Rnd 2: Knit to end.

Pinafore
Back and Front Alike

Shape Armholes
After decreases should say.
Continue in st st until armhole measures 7 [7:8:9:10:10] cm, ending with a WS row.

Also after
Shape Neck
Dec 1 st at neck edge on every row to 6 [7:8:9:10:11] sts.

On other side of neck also
Dec 1 st at neck edge on every row to 6 [7:8:9:10:11] sts.

For the long sleeve option the pattern says change to 4mm needles and proceed as follows: The 5th row reads 'As 7th row'. We can confirm that the 5th row should read Knit and not as 7th row.

Back
After pattern row 4, set 4 more rows for the 8 row side and middle cables:
Row 5: (K1, P1) 4 [7:10:13:16:19] times, P1, C4F, C4B, P1, work next 27 sts as given for row 5 of cable panel, (P1, C4F, C4B) 3 times, P1, work next 27 sts as given for row 5 of cable panel, P1, C4F, C4B, P1, (P1, K1) 4 [7:10:13:16:19] times.
Row 6: (P1, K1) 4 [7:10:13:16:19] times, K1, P8, K1, work next 27 sts as given for row 6 of cable panel, (K1, P8) 3 times, K1, work next 27 sts as given for row 6 of cable panel, K1, P8, K1, (K1, P1) 4 [7:10:13:16:19] times.
Row 7: (P1, K1) 4 [7:10:13:16:19] times, P1, K8, P1, work next 27 sts as given for row 7 of cable panel, (P1, K8) 3 times, P1, work next 27 sts as given for row 7 of cable panel, P1, K8, P1, (K1, P1) 4 [7:10:13:16:19] times.
Row 8: (K1, P1) 4 [7:10:13:16:19] times, K1, P8, K1, work next 27 sts as given for row 4 of cable panel, (K1, P8) 3 times, K1, work next 27 sts as given for row 4 of cable panel, K1, P8, K1, (P1, K1) 4 [7:10:13:16:19] times.
These 8 rows set Irish moss st, 8 row cable patt and cable panels.
Beg with row 9 of cable panel, working in Irish moss st and 8 and 16 row cable patt (throughout) cont until Back measures
52 [54:56:58:60:62]cm from cast on edge, ending with RS facing for next row.

Left
Front After pattern row 4, set 4 more rows for the 8 row side cables:
Row 5: (K1, P1) 4 [7:10:13:16:19] times, P1, C4F, C4B, P1, work next 27 sts as given for row 5 of cable panel, P1, C4F, C4B, P1.
Row 6: K1, P8, K1, work next 27 sts as given for row 6 of cable panel, K1, P8, K1, (K1, P1) 4 [7:10:13:16:19] times.
Row 7: (P1, K1) 4 [7:10:13:16:19] times, P1, K8, P1, work next 27 sts as given for row 7 of cable panel, P1, K8, P1.
Row 8: K1, P8, K1, work next 27 sts as given for row 8 of cable panel, K1, P8, K1, (P1, K1) 4 [7:10:13:16:19] times
These 8 rows set Irish moss st, 8 row cable patt and 16 row cable panels. **
Beg with row 9 of cable panel, working in Irish moss st and 8 and 16 row cable patt (throughout), cont until Left Front measures 44 [45:47:48:50:52]cm from cast on edge, ending with WS facing for next row.

Right
Front After pattern row 4, set 4 more rows for the 8 row side cables:
Row 5: P1, C4F, C4B, P1, work next 27 sts as given for row 5 of cable panel, P1, C4F, C4B, P1, (P1, K1) 4 [7:10:13:16:19] times.
Row 6: (P1, K1) 4 [7:10:13:16:19] times, K1, P8, K1, work next 27 sts as given for row 6 of cable panel, K1, P8, K1.
Row 7: P1, K8, P1, work next 27 sts as given for row 7 of cable panel, P1, K8, P1, (K1, P1) 4 [7:10:13:16:19] times.
Row 8: (K1, P1) 4 [7:10:13:16:19] times, K1, P8, K1, work next 27 sts as given for row 8 of cable panel, K1, P8, K1.
These 8 rows set Irish moss st, 8 row cable patt and 16 row cable panels. **
Beg with row 9 of cable panel, working in Irish moss st and 8 and 16 row cable patt (throughout), cont until Right Front measures 44 [45:47:48:50:52]cm from cast on edge, ending with RS facing for next row.

Sleeves
These 4 rows set Irish moss st, 8 row cable patt and 16 row cable panels.
Beg with row 5 of cable patt and cable panel, working in Irish moss st and 8 and 16 row cable patt (throughout), inc 1 st at each end of next and every foll 6th [6th:4th:4th:4th:4th] row to 65 [77:79:91:103:113] sts, then on every foll 8th [8th:6th:6th:6th:6th] row to 83 [91:101:109:113:117] sts, working inc sts in Irish moss st.

Front
Should say: Cont in st-st until armhole measures 14 rows less than back to shoulder shaping, ending with a RS row.

Sleeves (Both Alike)
The second next row should say:
Next Row: Using B, P10 [10:11:11:11:12], m1p, (p10 [11:11:12:13:13], m1p) 3 times, p9 [10:11:10:11:12]. 53 [57:59:61:65:67] sts.

Instructions for the back should read:
Row 7: K4B, *k2a, k2B, rep from *to last 2 sts, k2B
Row 8: P2B, *p2B, k2A, rep from * to last 4 sts, p4B

Left Front
Shape Neck
Should say after shaping.

Cont straight till front measures the same as the back to the shoulders, ending with a WS row.

Right Front
Shape Neck
Should say after shaping.

Cont straight till front measures the same as the back to the shoulders, ending with a RS row.

It has been brought to our attention that the design of this cardigan does not mirror image the Fair Isle up the centre fronts. To achieve a mirror image on the centre fronts please work Chart row 2 as follows:

Chart Row 2 (WS): Starting at stitch number 3 (5:9:13:1:7:11) work from L to R across Row 2 of Chart working patt rep 3 (3:3:3:4:4:4:4] times, ending row working sts 16 to 14 again.

Cable Panel Chart A, B & C Key should read:RS: Purl. WS: Knit.

Pockets (Both Alike)

After 'work in Double Moss Stitch until work measures 10cm, ending with a WS facing for next row.' the pattern should say:

Break off M and join C.
Next row: Using C, P5, m1p, p9, m1p, p5. 21 sts.
Next row: K2, MB, (K3, MB) 4 times, K2.
Next row: Purl to end.
Change to 6mm needles and work in rib as
set on Back until Pocket measures 16cm, ending with RS facing for next row.
Cast off in rib.

Border should say:

Join shoulder seams.

On back page of leaflet, in the sections 'Commence Chart B, Commence Chart C and Commence Chart D', in Round 3 of each, it should read 'Work round 3'.

Row 1: K3, work 109sts as set on row 1 of chart A working 18st rep 5 times, K3.

Row 2: K3, work 109sts as set on row 2 of chart A working 18st rep 5 times, K3.

Errata on chart

Chart A
Row 19 and stitch 17 has \ symbol for sl 1, k1, psso. Missing

Yarn amounts corrected to the following:
Ribbed Edge: Blush (287) 2 [3:3:4:4:5] 50g hanks
Garter Stitch Edge: Mist (166) 2 [3:3:4:4:5] 50g hanks

Finishing For Short Version with Collar

Buttonhole Border 

With RS facing and using 3.25mm needles, pick up and K51 [59:61:65:71:75:87] sts evenly up right front edge. 

Button Border 

With RS facing and using 3.25mm needles, pick up and K51 [59:61:65:71:75:87] sts evenly down left front edge.

At the end of toe

Both sizes
Sl st in next st to finish toe.

After Round 5.
Rep pattern 3[4] more times or required length for foot, ending with Round 5.

Afterthought heel (for both types)
Should say
Work 3dc in each 3ch-sp and 1dc in dc, place green marker on last st, now working along the ch, work 1dc in each ch, place red marker in last st. 42 [48] sts.

Neckband
Using 4mm (US6) needles, rejoin yarn, K40 [40:40:40:40:42:42:44]sts left on holder for back neck, pick up and knit 18sts evenly down left front neck, work across 24 [24:24:24:24:26:26:28]sts from front neck holder as follows:-
K6 [6:6:6:6:7:7:8], (k2tog, K1) 4 times, K7 [7:7:7:7:8:8:9].
96 [96:96:96:96:100:100:104]sts.
Now work rib as follows:-
Complete as given in pattern.

Rnd 1: [K1, p1] to end.
Rep this round until cuff measures 4cm, (1½in) from cast on edge.
Change to 3.25mm (US 3) DPNs.
Next rnd (inc): (k3, m1) 18 times. 72 sts

Round 50:K20 [22:24], yo, k3togtbl, yo, k1, yo, k3tog, yo, k22 [24:26], yo, k3tog, yo, k3, yo, k3togtbl, yo, k2.

Cable Panel Chart Key should read:
RS: Purl WS: Knit.

Cable Panel Chart A & B & Key should read:
RS: Purl WS: Knit.

Gauge should read.
30 stitches per 4 inches (10cm) in stocking stitch (worked in the round) on 2.5mm needles.

Yarn amounts corrected to the following:
Cardigan One: Dandelion (446) 2 [2:3:3:4] 50g hanks
Cardigan Two: Mist (166) 2 [3:3:4:4] 50g hanks

Actual Size should be: Actual Size Excluding borders 78 [84:96:108] cm.

Row 3 has yf instead of yo. Both mean the same but need to be consistent.
CABLE PATTERN
Row 3: K2, yo, slip next 2 sts onto a cable needle and hold at front of work, K2tog from left hand needle, K2tog from cable needle, yo, K2.

Version 1, 4th Row should be4th row: S1, K2, *P2, K2, rep from * to last st, K1.